Important Safety Instructions; Parts Identification; Before Use - Panasonic ER508 Mode D'emploi

Thank you for purchasing the
Panasonic Hair Clipper Model
No.ER508.
Important safety
instructions
Basic safety instructions, including
those listed below, must be observed
when using electrical appliances.
<Warning>
Failure to observe the following may
result in death or serious injury.
1) Do not use the clipper with AC
operation in locations subject to
high humidity, such as in bath-
rooms and shower rooms.
• Failure to observe this may
result in electric shocks, fires or
malfunctions.
2) Disconnect the AC adaptor from
the wall socket when cleaning the
clipper.
• Failure to observe this may
result in electric shocks.
3) Do not plug in or disconnect the
AC adaptor with wet hands.
• Failure to observe this may
result in electric shocks.
4) Do not place the AC adaptor in
water. Never wash it in water or
allow it to get wet.
Do not wipe it with thinner,
benzine or alcohol.
• Failure to observe this may
result in electric shocks.
5) Do not disassemble the clipper.
Do not modify the clipper.
Do not attempt repairs.
• Failure to observe this may result
in fires, electric shocks or other
injuries. Repairs must always be
requested to your dealer.
6) Do not use the clipper if the
electric cord or the AC adaptor is
worn, or if the AC adaptor does
not fit snugly in the wall socket.
• Failure to observe this may
result in electric shocks, short
circuits or fires.
7) Do not damage, cut, modify, twist,
forcibly bend or pull the electric
cord. Do not place heavy objects
on the electric cord or trap it
between objects.
• Failure to observe this may
result in electric shocks or fires.
8) Only use the clipper with 230V
AC power supplies.
• Failure to observe this may
result in electric shocks or fires.
9) Clean the electric plug regularly
to remove any dust or dirt.
• Dust or dirt adhering to the electric
plug may reduce insulation
capabilities owing to moisture in
the air, resulting in fires.
<Cautions>
Failure to observe the following may
result in injuries or physical damage.
1) Do not use force to press the
blade against the skin, and do not
apply excessive pressure to the
outer blade.
• Failure to observe this may
result in injuries to the skin or
damage to the blades.
4
2) Do not use the clipper for any
purpose other than trimming.
Do not use to trim the hair of a pet.
• Failure to observe this may
result in injuries to the skin.
3) Check that the blades are not
damaged or deformed before use.
• Failure to observe this may
result in injuries to the skin.
<Important>
1) When disconnecting the AC
adaptor from the wall socket,
always grip the AC adaptor and
not the electric cord.
• Failure to observe this may result
in electric shocks or short circuits.
2) Do not store or charge the clipper
in a place exposed to direct
sunlight or near a heater or other
source of heat.
• Failure to observe this may
result in malfunctions or
deformations.
3) Lubricate the clipper before use.
• Failure to observe this may
result in the blades becoming
dull or abnormal noises.
• Failure to observe this may
result in the blades becoming
hot and the deterioration of
cutting performance.
4) Never allow charging to continue
for longer than 48 hours.
• Failure to observe this may
result in shorting the life of the
rechargeable battery.
5) The hair clipper may become
warm during operation and/or
charging.
This is normal.
6) Keep out of the reach of children.
7) Do not attempt to charge the
clipper at temperatures below 0°C
or above 40°C. Charging cannot
be done correctly under such
conditions.
This clipper is indoor use only.
8) Do not attempt to use any power
cord or adaptor other than one
specifically designed for this
model. Use only adaptor RE5-79.

Parts identification

ABlade
BAttachment mounting
CSwitch
DBody
EIndicator lamp
F10/20/30/40mm comb attachment
G3/6mm comb attachment
H9/12mm comb attachment
IThinning (1/3) attachment
JMoving blade
KFixed blade
LLever for cleaning
MAC adaptor
NElectric cord
OOil
PCleaning brush

Before use

Before using each time, apply oil at
the places marked with arrows in
Fig.19.
5