Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Table 1 Minimum gauge for extension
Volts
120V
240V
Ampere rating
more than not
more than
0-6
6-10
10-12
12-16
NoTE: Only the applicable parts of the
Table need to be included. For instance, a
120-volt product need not include the240-
volt heading.
Figure 1
METhod oF SEcuriNG ExTENSioN
cord
14
14
APPLIANCE CORD
CORD
SET
(A) TIE CORD AS SHOWN
(B) CONNECT PLUG AND RECEPTACLE
Guarded electric chain saw
cords
Total length of cord in
feet
25
50
100
150
50
100
200
300
AWG
18
16
16
18
16
14
16
16
14
Not
14
12
recom-
mended
ADDITIOnAL SAfeTy
InSTRUCTIOnS
wArNiNG: do not overreach.
wArNiNG: do not use this tool to
fell trees
•
Pre-plan a safe exit from falling branches
and debris. Ensure the exit route is clear
of obstacles that would prevent or hinder
movement. Remember freshly cut bark and
wet grass is slippery.
12
•
Be aware of the direction that a branch may
12
fall. Consider all conditions that may affect
the direction of fall. Including:
12
• The intended direction of fall
• The natural lean of the branch
• Any unusual heavy limb structure
or decay
• Surrounding trees and obstacles
including overhead power lines.
• The wind speed and direction.
•
The safe distance between a branch and
debris to be trimmed and bystanders,
buildings, and other objects is at least
2 ½ times the length of the branch. Any
bystander, building, or object within this
distance is at risk from being struck by the
falling branch.
•
When cutting a limb that is under tension
be aware of spring back. When tension
in the wood fibres is released the spring
loaded limb may strike the operator and/or
throw the tool out of control.
•
Always wear suitable safety equipment
such as no-skid heavy-duty shoes, goggles,
ear protection, face shield, and gloves
when operating this tool.
•
Ensure someone is nearby (at a safe
distance) in case of an accident.
•
Do not attempt to operate this tool when
in a tree, on a ladder, or standing on other
unstable support.
•
Keep proper footing and balance at all
times.
•
Keep handles dry, clean, and free from oil
and grease.
•
Do not let the moving chain contact any
object at the tip of the guide bar.
•
Begin and continue cutting only with the
en
Publicité
Table des Matières
