Turning The Water On - Whirlpool EZ CONNECT Guide D'installation

Turning the water on

NOTE: Be very careful when you tighten the
compression nuts that you do not overtighten
them and destroy the compression sleeving
and the end of the soft copper tubing. If this
happens, you will have to cut off the end of
the tubing, purchase a new compression
sleeve, and start over. Be careful and go
slow!
1. Turn on the water supply and check the
shut-off valve for leakage. If necessary,
refer to the side diagram, and tighten the
compression nut on the shut-off valve in
small increments until the leakage just
stops . Wipe off the connection with a cloth
each time you check for leaks.
2. Check the water valve for any leakage. If
necessary, tighten the compression nut
(see the side diagram) in small increments
until the leaking just stops .
12
Shut-off
valve
Open
T-handle
Tightening the shut-off valve connection
Water
valve
Tightening the water valve connection
Water flow
Compression nut
Compression
nut
Water inlet
fitting