Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9．Lanyard Installation
1. Pass the thinner end of the lanyard through the slot on the device as
shown in Fig 12.
2. Then Pass the thicker end of the lanyard through the thinner loop of
the lanyard and pull tightly as shown in Fig 13.
Figure 12
Warning ！
1.Due to small parts, always keep the device out of reach of children.
2.Never leave the device hanging on its lanyard in reach of small children.
10．Product Accessories
No.
Name
1
Lanyard
2
AAA batteries
3
User's Manual
Figure 13
Unit
Quantity
Piece
1
Piece
2
Piece
1
9
11．Maintenance, Storage and Transportation
The life cycle of this device is 5 years when used daily for a number of 10
measurements, for periods of 10 minutes each measurement. In order to
conform to this service life please pay information below:
1. Please replace the batteries immediately when the low battery power
symbol is indicated.
2. Wipe the surfaces of the device before and after use.
3. Remove batteries for extended periods of none use.
4. Expected service life is 5 years.
5. The device has been calibrated before delivery,Therefore there is no
need for user calibration.
6. A packaged device should be stored in a clean and well ventilated
environment with an ambient temperature of -20℃ ~55℃ with relative
humidity ≤ 93% and in the absence of corrosive gases,strong mechanical
vibration or electromagnetic fields.
7. For transportation requirements, devices should be loaded correctly
according to the symbols on the outer packaging and should be
protected against collision and impact, severe vibration and severe
weather conditions whilst in transit.
8. The device shall be kept dry at all times.High moisture enviroments will
afect the service life of the device and potentially cause damage.
9. Do not attempt to disassemble, repair or service the device.
10.To recycle or dispose of the device and batteries, please comply with
local authority regulations.
·If there is dust or dirt on the surface of the oximeter, wipe the device with
70% alcohol.Dip a dry cloth or alcohol pad in a small amount of alcohol
before wiping. Avoid drip or flow of alcohol in the device. Dry the device
in the air after wiping. Avoid permeation of any liquid into the device.
·The device does not need scheduled maintenance or calibration except
for battery replacement.
·Please stop using the device and contact your local service center
immediately if any of the following conditions occurs:
1. Abnormal alphabet or number appears on the screen.
2. The device cannot be turned on despite replacement of batteries.
3. The device cannot perform measurement due to squeezing, loose
spring, button failure and so on.
10
Publicité
Chapitres
Table des Matières
