VONROC CS501DC Traduction De La Notice Originale page 12

EN
4. OPERATION
Switching the machine on/off (Fig. A)
• To start the machine, press and hold the lock-
off button (1) and press the on/off switch (2).
• To stop the machine, release the on/off switch (2).
Switching the laser on/off (Fig. A)
• Press the laser switch (3) to switch the laser on
or off. The laser switch (3) also turns on the LED
worklight.
Fine-tuning the laser
Note: To test the laser function, the battery must be
inserted into the power tool.
While adjusting the laser, never activate the
on/off switch. Accidental starting of the
power tool can lead to injuries.
If the laser (5) ceases to indicate the correct
cutting line, you can readjust the laser. To do so,
adjust the laser adjustment screw (25) and set the
laser until it indicates a correct cutting line.
Adjusting the bevel angle (Fig. A, B)
The 0° cutting mark (9) indicates the position of the
saw blade for straight cuts. The 45° cutting mark (8)
indicates the position of the saw blade for 45° cuts.
1. Loosen the wing bolt (7)
2. Adjust the baseplate (17) to the desired posi-
tion (0°- 45°). The sawing angle (bevel) can be
read on the scale (6).
3. Tighten the wing bolt (7).
Adjusting the cutting depth (Fig. C)
1. Loosen wing bolt (22).
2. Move the baseplate (17) to the desired position.
The sawing depth) can be read on the scale (23).
3. Tighten the wing bolt (22).
Optimum use
• Hold the work using clamps or a vice to have
both hands free to operate the saw.
• Switch on the saw and place the bottom plate
on the work.
• Slowly move the saw towards the previously dra-
wn cutting line and slowly press the tool forward.
• Firmly press the bottom plate on the work,
otherwise the circular saw may start to vibrate,
causing the blade to break more easily.
12
• Let the saw do the job. Do not put undue pres-
sure on the circular saw.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Re-
move very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
WWW.VONROC.COM