De-Registration - Gigaset Repeater HX Mode D'emploi

Preparing
Overview
Preparing
Please refer to the user guide for your phone/router to check whether your base is suitable for
operating the repeater and how to prepare it for registering the repeater.
Before starting registration, position the Gigaset Repeater directly adjacent to the base station
and to a power connection. If you are already using Gigaset Repeaters, these must be switched
on and positioned close to the base station for this registration procedure.
Automatic registration
Carry out the following steps:
¤
Switch on Gigaset Repeater: Connect the power supply unit to a plug socket. Following this,
the device will enter registration mode for 5 minutes.
¤
Prepare the base station for registering the repeater, in the same way as you would to man-
ually register a handset. Please refer to the operating instructions for your base station.
The repeater will automatically be registered to the base station. The LEDs will indicate whether
registration was successful or unsuccessful, see page 15.
Ensure that no other base stations in registration mode are located close to the
Gigaset Repeater during this procedure.

De-registration

It may be necessary to de-register the repeater, for example if it has to be replaced. Information
about this can be found in the operating instructions of your base station, or via the system
menu of your phone e.g. C430/C430A, C530/C530A, CL660/CL660A, E630/E630A. For phones
without a repeater system menu, the repeater can be de-registered using the Reset Repeater
procedure, see page 16.
14
Front
Two function lights (LEDs) indicate the different operating modes
(Explanation see page 15).
Back
Repeater button (for reset see page 16 and to activate/deactivate the veri
tone see page 16)
Socket for power supply unit
¤
Plug the lead from the power supply unit provided into the socket.