IQAir Atem Mode D'emploi page 13

Product Use and Operation
EN
Lift tabs to remove filter
Step 3: Remove the old filter by pulling on the tabs
and then dispose of it. Replace with a new IQAir
Atem HyperHEPA
place.
Step 4: Put the back cover on and gently rotate until
the lock pins align into place. Grasp firmly and press
down on the locking ring and turn clockwise to lock.
The back cover should now be closed securely.
Attach the air purifier to the stand for use.
PureJet Diffuser
To remove your PureJet diffuser, firmly grasp the air
purifier and pull off the diffuser.
Removal of the diffuser
To attach your PureJet diffuser firmly grasp the air
purifier and align the large pins on the diffuser with
the arrows on the outlet vent. Note the outlet vent
has larger openings.
Locate outlet vent arrows
Connector hook
9
Turn clockwise to lock
filter (6) and firmly press into
®
Align the large pins with
the arrows
Once the diffuser pins
are aligned with the vent
arrows press firmly into
place while holding the
air purifier.
Should the PureJet
diffuser grille become
dislodged, align the
hook at the bottom of
the diffuser grille with the
bottom of the diffuser
body and snap firmly into
place.
Diffuser grille snaps into place