Using The Appliance; Setting The Alarm Time - Philips HF3451/01 Mode D'emploi

Note: After you have set the time for the first time, you have to press the 'set time' button before you can
adjust the time again. The time on the display starts flashing and arrows appear above and below the
time to indicate that the clock time can be set.
 When you have set the correct time, press the 'set time' button to confirm the time (Fig. 6).
The time on the display stops flashing and the arrows disappear.
,
Note: If you do not confirm the time, the flashing stops and the arrows disappear after 10 seconds. This
indicates that the time has been set.
The appliance is now ready for use.

Using the appliance

setting the alarm
When you set the alarm, you choose the light intensity level, the type of sound and the sound level.
The alarm is set when the light ring round the ALARM button burns. The light intensity slowly
increases to the chosen level during the last 30 minutes before the set alarm time. The sound slowly
increases in 90 seconds to the chosen level after the set alarm time.

setting the alarm time

1 Press the alarm time button ( *) to set the alarm. (Fig. 7)
The alarm time starts flashing and two arrows appear above and below the alarm
,
time (Fig. 8).
2 Use the % and the ^ buttons to set the alarm time, i.e. the time at which you wish to get
up. (Fig. 9)
 Press the button longer to put the time forward or backward more quickly.
 Press the alarm time button ( *) again to confirm the alarm time. (Fig. 7)
The arrows disappear and the alarm time stops flashing.
,
Note: If you do not confirm the alarm time, the flashing stops after 10 seconds. This means that the
alarm time has been set.
setting the sound and the sound level
1 Press the ALARM button (Fig. 10).
The light ring round the ALARM button goes on (Fig. 11).
,
The first sound symbol (radio symbol for HF3462/HF3461 and gentle beep symbol for
,
HF3451) flashes for 3 seconds and the sound can be heard.
2 Press the ALARM button again if you want to select another wake-up sound. When you have
found the sound you want to use, do not press the ALARM button again (Fig. 10).
After 3 seconds, the symbol of the sound selected stops flashing to indicate that it has been
,
selected.
The alarm has been set and continues to work until you switch off the alarm function. When
,
you do this, the sound symbol disappears from the display and the light ring round the
ALARM button goes out. See also section 'Switching the alarm on or off'.
 Turn the volume control wheel $ to set the sound level. (Fig. 12)
The $ appears on the display. (Fig. 13)
,
 If you want no sound at wake-up time, select level 0.
setting the light intensity level
1 Use the light adjustment wheel @ to set the light intensity level. (Fig. 14)
The @ appears on the display.
,
EnglisH
9