Maintenance; Storage - Max PJRC160 Manuel D'utilisation

5. HOW TO CHANGE THE BLADES
CAUTION
• To change the blades, be sure to remove
the battery from the tool.
• Use due caution when handling the blades
because they are sharp.
• Pay attention to the direction in which the
blades are installed. (Fig.L)
• Securely tighten the hexagon bolts that
lock the blade in place. (Fig.K)
1 Loosen the hexagon bolts (2 for each
blade) that lock the blade in place with
the hexagon wrench #4 and remove the
old blade.
2 Set the new blade as shown in the Fig.L
and securely tighten the hexagon bolts.

7. MAINTENANCE

WARNING
• Before inspecting the tool, make sure that
the Battery pack is not set in the tool.
Failure to do so may cause serious injury.
• Before inspecting the Battery charger,
make sure that the Charger is disconnected
from the power supply.
1 Regularly inspect the tool
In order to maintain the performance of the
tool, periodically clean up and inspect the
tool.
Examine the screws regularly to make sure
they are securely tightened.
Incomplete tightening may result in an acci-
dent or breakage. If a screw is loose, retight-
en it completely.
2 Do not lubricate the equipment
Absolutely do not lubricate this equipment.
Applying lubrication will remove the grease
inside of the tool, and cause problem on the
tool.
3 Do not soak the tool to any liquids. Do not
put any liquid except the specified oil in
the tool.

8. STORAGE

Do not store the tool in a cold weather environ-
ment. Keep the tool in a warm area.
When not in use, the tool should be stored in a
warm and dry place. Keep out of reach of chil-
dren. All quality tools will eventually require serv-
icing or replacement of parts because of wear
from normal use.
STORE THE TOOL
When you have finished using the tool or when
the tool will not be used for a while, remove the
battery pack from the tool. Tool, attachments and
accessories should be stored in a well-ventilated
dry place where the temperature will not exceed
40°C (104°F) and not become less than -20°C (-
4°F).
The battery pack, with a pack cap installed on
the pack's terminal to prevent short circuits,
should be stored in a well-ventilated dry place
where the temperature will not exceed 30°C
(86°F) and not become less than -20°C (-4°F).
CAUTION
WHEN STORING THE BATTERY PACK FOR A
LONGER TIME THAN 6 MONTHS WITHOUT
USE,
TO KEEP THE PERFORMANCE OF THE BAT-
TERY PACK, FOLLOW THESE INSTRUC-
TIONS ;
• Fully recharge before storage.
• Put a Pack cap on the Battery pack's termi-
nal to prevent short circuits.
• Store the Battery pack in a well-ventilated
dry place where the temperature will not be
less than -20°C(-4°F) and will not exceed
30°C (86°F).
• Do not store the Battery pack in a place
where is under direct sunshine.
16