Applications; Battery Instructions - Max PJRC160 Manuel D'utilisation

2. TECHNICAL DATA
1 NOISE
The typical A-weighted noise level deter-
mined according to EN60745-1:
• Sound pressure level (L
• Sound power level (L
• Uncertainty (K):
Wear ear protection
2 VIBRATION
The vibration total value (tri-axial vector
sum) determined according to EN60745-1:
• Vibration emission: (a
• Uncertainty (K):
3 RADIATED EMISSION 30-1000 MHZ
Class B
4 Overvoltage category
PRODUCT
PJRC160 CORDLESS
RE-BAR CUTTER
JPL92530A BATTERY
PACK
JC925A(CE)
BATTERY CHARGER
5 Pollution degree
Pollution degree : degree 4 according to IEC
60664-1 (Both of PJRC160 and JC925A(CE)).

3. APPLICATIONS

Cutting of the following materials
• Rebar
• Bolt
• Mesh Wire
4. ABOUT PRODUCTION YEAR
This product bears production number in the
body. The two digits of the number from left
indicates the production year.
(Example)
1 9 8 2 6 0 3 5 D
Year 2019
): 91dB (A)
pA
): 80dB (A)
WA
3dB (A)
2
≤2.5m/s
, ):
h HD
2
1.5m/s
Overvoltage category
Battery
according to
IEC 60664-1
Category I according
to IEC 60664-1
Category II
according to
IEC 60664-1

5. BATTERY INSTRUCTIONS

1. CHARGING
BATTERY PACK BREAKDOWNS
If the following conditions occur, bring the Bat-
tery and Charger to your dealer.
• The red charging lamp does not flash when the
charger plug is inserted into main power
source outlet (When the Battery pack is not in-
serted in the charger.)
• Neither the red charging lamp nor the orange
standby lamp lights or flashes when the Bat-
tery pack is inserted in the charger.
• The orange standby lamp does not change to
the red charging lamp even after more than 1
hour. (except at low temperatures)
• The red charging lamp does not change from
constant to flashing light even after more than
90 minutes.
SERVICE LIFE OF BATTERY PACK
If any condition described below is observed, the
battery pack is at the end of its service life. Re-
place it with a new one.
• Although the battery pack has been properly
charged (fully charged), a great drop in operat-
ing time has been noticed.
NOTICE:
• Charge the battery pack when the motor's ro-
tational speed slows down (the Capacity of the
battery pack is considered to be nearly run
out). Using the tool more will cause it to over-
discharge, resulting in a shortened service life
of the battery pack and also in functional trou-
ble of the tool's main body.
• Do not use a battery pack when its service life
is finished.
This will cause functional trouble in the tool's
main body. Also charging a battery pack that is
out of service life will lead to functional trouble
in the battery charger.
12