Ayce 2604A Manuel D'utilisation page 5

Read this manual carefully before using this product and check whether there are any damaged
parts. The product cannot be installed in case of damages. Keep this manual for further reference.
SAFETY WARNINGS:
a) The installation must be carried out by a qualified electrician.
b) Please check whether the connection of the power cord is safe and reliable before installation.
c) When the light bulb is burning or not completely cooled down, please do not touch it.
d) A class II product.
e) IPX4: Splash-proof.
f) When the protection glass is damaged, it should be replaced immediately. The lamp must not be used
without the protectionn glass.
EXPLANATION OF SYMBOLS:
Conforms to relevant European requirements for the product.
The crossed-out wheeled bin symbol indicates that the item should be disposed of
separately from household waste. The item should be handed in for recycling in
accordance with local environmental regulations for waste disposal. By separating a
marked item from household waste, you will help reduce the volume of waste sent to
incinerators or land-fills and minimize any potential negative impact on human health
and the environment.
TECHINICAL DATA:
Humidity-proof light
Type 2604A
Rated voltage 220-240 V ~ 50 Hz
Rated power Max. 60 W
IP Level IP44
Electric shock
II
protection class
Lamp socket size E27
Weight
0.5 kg
CLEANING:
Turn off the power to clean the lamp and let the lamp cool down. Clean the lamp with soft
cloth (if necessary slightly moistened). Never use alcohol or a similar solvent, this could
damage the lamp.
INSTALLATION:
Switch the power off before the installation.
The external power cord must be a VDE-certified H05RN-F 2x1,0mm2 waterproof cable.
Please put the shrinkage hose on the cable at the joint.
1. Take the metal hoops and glass cover off. The the rubber caps off and make holes for the
wire connection (Fig. 1-5).
2. Fix the cable through the caps and then fix the cap on the lamp body. Connect the brown
wire with the L terminal (marked with "L") and blue wire with the other terminal of the
lamp hodler (Fig. 6-7).
3. Screw the light bulb into the socket. The power of the light bulb should not exceed the
maximum power of the lamp (Fig. 8-9).
4. Mount the upper cover and fix it with metal hoops. Make sure the rubber gasket is in the
right place (Fig. 10-12).
5. Choose the designed place of the lamp installation, the fix t
tighted the screws to fix the lamp well.
8mm
4cm
CHANGING THE LIGHT BULB:
1. Switch the main switch off and cool down the bulb.
2. Open the lamp cover.
3. Unscrew the cooled down light buulb cautiously.
4. Screw the new light bulb into the socket.
5. Close the lamp cover before switching on the lamp.
I
GB
07 08
he lamp base with screws and