Klarstein BARETT Mode D'emploi page 36

EN
36
Activated carbon filter
Activated carbon filters can be used to remove odours. Normally, the activated charcoal
filter should be changed after three or six months, depending on your cooking habits.
The installation of the activated carbon filter is done as follows:
1 Disconnect the extractor bonnet from the power supply before installation.
2 Press the filter lock and remove the mains filter.
3 Rotate the carbon filter counter-clockwise on both sides of the motor. Replace the
old carbon filters with new carbon filters.
4 Replace the mains filter.
5 Reconnect the power cord to the power socket.
Note: Make sure that the filter is tightly closed. It can otherwise detach and become
dangerous. If an activated carbon filter is connected, the suction power is reduced.
close
open