USRobotics 5637 Guide D'installation Rapide page 14

English
My PWR LED is not lit.
S o l u t i o n 1 :
The PWR LED does not light until the drivers are installed. Make sure
that the drivers are installed correctly by following the general trouble-
shooting procedure above.
S o l u t i o n 2 :
When you insert or remove a USB cable from your computer, the compu-
ter should indicate activity such as hard disk activity or an hourglass cur-
sor. If the computer does not show any sign of activity, your system may
not be properly communicating with the USB ports. Try these techniques
to determine whether the ports are communicating properly:
1. Try using a different USB port on the computer. If you are using a
USB hub, try using a USB port on the computer instead.
2. If the modem has worked previously and you removed the USB cable
from the computer and then reconnected it, try another USB port.
The modem may have been installed originally on the other USB port.
3. Windows Users: Your USB port may not be enabled. To ensure that
USB is enabled on your system:
A. Go to the device manager:
Windows Vista:
1) Click Windows Start > Control Panel > System and Main-
tenance > System.
2) Under Tasks, click Device Manager.
Windows XP:
1) Click Windows Start > Control Panel.
2) Double-click System.
3) On the Hardware tab, select Device Manager.
Windows 2000:
1) On the desktop, right-click My Computer and select Proper-
ties.
2) On the Hardware tab, click Device Manager.
10