Loading Nails - Hitachi NR 65AK2 Manuel D'instructions Et De Sécurité

English

LOADING NAILS

WARNING
When loading nails into Nailer,
1) do not depress trigger;
2) do not depress push lever; and
3) keep your face, hands feet and other
body parts, as well as those of other
persons away from the nose muzzle to
avoid possible injury during usage and
carrying.
Do not insert di erent length sized nail
strips at same time. If do so, it could result in
damaging nail strips and jamming.
Always point fi rst nail protruded from the
nose away yourself and others.
Keep your face, hands, feet, other body parts
as well as those of other person away from
the nose muzzle to avoid possible injury
during usage and carrying.
Nail point
(1) Adjust the proper position of the nail gate of the
magazine end for the nail length.
There are 2-positions, lower position for 1-1/2"
(38 mm) length and upper position for 2-1/2" (64 mm)
length.
Nail Gate
14
000Book̲NR65AK2̲NA̲lowes.indb 14 000Book̲NR65AK2̲NA̲lowes.indb 14
When nails are loaded in the magazine, the nail
gate can not be changed to the other position.
(2) Insert nail strips from rear of magazine.
(3) Slide the nail strip forward in the magazine.
The nail strip should pass over the nail stopper, which
means it is in proper position.
Nail Stopper
Nail Strip
(4) Pull the nail feeder back with depressing the feeder
plate knob to push the nail strip.
Feeder Plate Knob
NOTE: Use nail strip of more than 5 nails.
The Nailer is now ready to operate.
Nail
Feeder
Feeder
Plate Knob
2018/03/09 15:49:15 2018/03/09 15:49:15