GMC GMC1252G Traduction Des Instructions Originales page 13

Troubleshooting
No function when On/Off Trigger Switch (7) is operated
Cutting disc is off centre/vibrating eccentrically
No power
Lock-Off Button (5) not pressed in
Defective On/Off Trigger Switch
Grinding/cutting disc is overly worn
Deformed grinding/cutting disc
Grinding/cutting disc not fitted correctly
13
Check power supply
Make sure the Lock-Off Button (5) is depressed before operating On/Off
Trigger Switch
Replace the On/Off Trigger Switch at an authorised GMC service centre
Turn off the grinder, remove and replace the disc, as instructed in 'Fitting
a grinding or cutting disc'
Turn off the grinder, remove and replace the disc, as instructed in 'Fitting
a grinding or cutting disc'
Turn off the grinder and refit the disc as instructed in 'Fitting a grinding
or cutting disc'
GB