Care And Maintenance - Blackstone 1605 Guide Du Propriétaire

CARE AND MAINTENANCE

Regularly clean your BLACKSTONE Griddle between uses and especially after extended pe-
riods of storage. Ensure that the BLACKSTONE Griddle and its components are sufficiently
cool before cleaning.
Never handle hot parts with unprotected hands. In order to extend and maintain the life and condition
of your BLACKSTONE Griddle, we strongly recommend that the unit be covered when left outside for
any length of time, especially during the winter months.
Burner maintenance
In most circumstances, burning off the residue after cooking will keep the burner clean. The burner
should be removed and cleaned annually or whenever heavy build-up is found in order to ensure that
there is no blockage (debris, insects) in either the burner portholes or venture tubes. Use pipe cleaner
to clear obstructions. A wire brush can be used to remove corrosion from the burner surfaces. When
refitting the burner, be careful to check that the venture tubes of the burner fit over the valve outlets.
Fittings and Storage
Annual checking and tightening of metal fittings is recommended. Store the grill in a cool dry place.
Cover the burners with aluminum foil in order to prevent insects or other debris from collecting in the
burner holes. If the grill is to be stored indoors, the gas bottle must be disconnected and left outside.
The gas bottle should always be stored outside, out of reach of children, and in a dry, well-ventilated
area away from any sources of heat or ignition.
Trouble Shooting
Problem
Burner will not light •
using the ignition
•
system.
•
•
•
•
•
Burner will not light •
with a match.
•
•
•
Fire in burner tube
has a low flame or
flashbackt
Possible Cause
Check battery.
LP gas cylinder is empty.
Faulty regulator.
Obstructions in the burner.
Obstructions in gas jets or gas hose.
Electrode wire is loose or disconnected on electrode or
ignition unit.
Electrode or wire is damaged/faulty pushbutton igniter.
LG gas cylinder is empty.
Faulty Regulator.
Obstructions in burner.
Obstructions in gas jets or gas hose.
• Obstructions in burner.
• Obstructions in gas jets or gas hose.
• Windy conditions.
Solution
• Replace with a good battery.
• Replace with full cylinder.
• Have the regulator checked or replaced.
• Clean burner.
• Clean jets and gas hose.
• Reconnect wire.
• Change electrode and wire change
igniter.
• Replace with full cylinder.
• Have the regulator checked or
replaced.
• Clean Burner.
• Clean jets and gas hose.
• Clean burner.
• Clean jets and gas hose.
• Use grill in a more sheltered position.
19