Testing, Warranty And Liability; Safety Rules; General Notes On Safety And For The User - Rico RIC M 30 S Instructions

•
Code of part to be ordered;
•
Required quantity;
•
Means of shipment;
8.5

TESTING, WARRANTY AND LIABILITY

Testing and inspection
• The entire unit is sent to the customer prearranged for installation, after passing the tests and inspections required by the
manufacturer, in conformity with the applicable laws.
Warranty
•
Warranties are defined in the general terms and conditions of sale.
Liability
• RICO S.p.A. cannot be held liable for operation faults or generic failures caused by improper use of the unit or operations carried out
by persons not authorised by RICO S.p.A.
9

SAFETY RULES

9.1

GENERAL NOTES ON SAFETY AND FOR THE USER

The instructions listed below must be read carefully and become a fundamental part of daily
procedures in the use and maintenance of all the equipment, in order to prevent any kind of accident,
injury or damage.
•
Do not start the unit until its operation is clearly understood.
•
If any doubts arise, despite having read this manual carefully and completely, contact RICO S.p.A.
•
Make sure all personnel involved in the use of the unit are informed regarding the safety requirements.
•
Before starting the unit, the operator must check the efficiency of the safety devices and for any obvious defects in the unit. In case
of any defects, immediately notify RICO S.p.A.
•
Check the proper operation of all the safety devices every day.
•
The safety devices must never be removed or disabled.
•
During maintenance or repair work it may be necessary to exclude some safety devices from the service. This operation must be
carried out by authorised personnel.
•
Never attempt rash solutions.
•
All installation, commissioning and maintenance operations must be carried out exclusively by qualified personnel.
•
Do not modify the electrical connections on the unit.
•
Do not wear clothes, jewellery or accessories that can get caught in moving parts.
•
Always keep the area around the unit free of obstructions.
•
Use appropriate PPE such as boots, gloves, goggles and work clothes.
•
Pay attention to all danger and caution signs placed on the unit.
•
Always apply and enforce the safety rules; in case of any doubts, always consult this manual before acting.
•
The unit must be used only and exclusively for its intended purpose and in accordance with that contractually established with RICO
S.p.A.
Non-compliance with the unit's intended use can cause serious accidents
The unit must only be started:
•
In conformity with the purposes of use, transport and handling specified in "FORESEEN USE",
•
respecting the values given in the "SPECIFICATIONS" and RATING DATA.
 Druckluftanlagenbau GmbH
RIC M30S – M120S
RIC M70RD – M120D
Tel. +49 ( 0 ) 2151 9931 99 - vk@rico-druckluft.com
34 / 126
- www.seitenkanalverdichter.de