Program Play; Relay Play; Fader Start - audiophony CD-3530 Guide De L'utilisateur

Operations

12. Program play

Press the PROGRAM button, the player will enter the program mode and the CD will stop rotating.
Select the desired track by pressing the SKIP button, then press the PROGRAM button again. The selected
track will be added to the program sequence.
Repeat step 2 operation. A maximum of 20 tracks can be programmed at one time.
Press the PLAY/PAUSE button to start the program play from the first selection.
Press the program button again during program play to stop play.
Press and hold the program button more than 2 seconds to cancel the program mode and erase all the current
program contents.
13. Loop Play
Press the LOOP button to set the loop start point A, the LOOP indicator will flashes on the LCD.
Press the LOOP button again to set the loop end point B, after the B point is set, the playback will enter the loop
play from A to B repeatedly.
Press the LOOP button again, the loop play function is canceled, the LOOP indicator goes out.

14.Relay Play

Press PROG and SGL button to switch relay function; the indicator on the LCD track display when flash when relay
is on.

15. Fader start

You have the possibility to start the respective CD-player directly from the mixer. Make sure that the Control socket is
connected with the respective socket on the mixer. Additionally, the Audio out socket have to be connected with the
Line-input sockets of your mixer. Please note that the Fader start function only works with the appropriate mixers.
Insert the CD and select the desired track. Start playback from your mixer.
Manuel CD-3530 version english V1.1 Juillet 05 - page 9