Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8
OVEN INSTALLATION
This oven cannot be properly installed without re-
ferring to the mounting instructions found on both
templates.
Read and follow mounting information on both
top cabinet template and wall template.
Mounting plate
Step 1- Setup position
• Draw a line down the middle of the studs. See
the Wall Construction, page 4.
• Draw a vertical line on the wall at the center of
the 30 in wide space. See Figure 18.
NOTE: use the wall template for the rear wall.
Reference wall template prior to proceeding. In-
stallation of this product requires 2 people.
Power Supply Cord Hole
House Duct
Figure 18
Step 2 - Drilling
• Reference the wall template.
Step 3 - Tightening the screws
To attach the mounting plate to the wall using the
toggle bolt assemblies and/or lag screws:
• Insert toggle bolts through the mounting plate
at required locations and add the spring loaded
toggles. See Figure 19.
Ensure you leave space at least the thickness
12 / 29 EN
Mounting Plate
Over The Range Microwave Oven / Installation Manual
of the wall between the mounting plate and the
end of the toggle nut, (in closed position). If you
do not leave this space, the toggle nut will not
open on the other side of the wall.
Mounting plate
Figure 19
• Position mounting plate on wall and insert tog-
gle bolt assemblies through the drywall holes or
start the lag-screw(s) through the wall stud(s).
See Figure 20.
Figure 20
• Secure the mounting plate to the wall by
tightening the toggle bolt assemblies or lag
screw(s). See Figure 21.
• Drill
⁄
in (4.7 mm) diameter lag screw hole(s),
3
16
into one or more wall studs.
You must have at least one lag screw into a
wall stud. For stud location refer to Wall Con-
struction.
• Tighten the lag screw(s) into wall stud(s).
Figure 21
Space more than
wall thickness
Dry Wall
Publicité
Chapitres
Table des Matières
