Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Note that it may be a cascading reception with a receiver as a target:
for example:
Repeater → repeater → Receiver
or
Repeater → repeater → ... → Receiver
1/ With the remote control unit already paired with the receiver, check the limit of the coverage using the LED of
the remote control unit as an indicator of the reception (Bi-colour LED: green for transmission and orange to
acknowledge that the receiver has received the command).
2/ When losing the reception (no acknowledge), step back until the reception is correct again.
3/ Install a repeater on this spot. After installing the repeater perform several link tests between the repeater and the
transceiver (cf. 4.2 TEST Mode).
Repeat this procedure if necessary with each repeater until the whole site is covered.
3.2 Mechanical Installation
3.3 Electrical connection
1
Install the repeater within the coverage
range of the LoRa receiver. Avoid
basements and parasitized areas. The
repeater must not be mounted on any
metal surface (rail, beam...).
2
A
Connect the 230VAC power cable to
the terminal block (A),
EN
11
Publicité
Table des Matières
