Troubleshooting; Reset Function; Troubleshooting Guide - Sony KV-SW34 Mode D'emploi

x

Troubleshooting

If you find any problem while viewing your TV, you can either use the Reset
function or check the Troubleshooting guide below. If the problem persists,
contact your Sony dealer.
RESET
RESET

Troubleshooting guide

Symptom
Snowy picture • The connection is loose
or the cable is
damaged.
• The antenna setup is
inappropriate.
Noisy sound
• Channel presetting is
inappropriate or
incomplete.
• Signal transmission is
low.
Distorted picture
• Broadcast signals are
too strong.
Noisy sound
Good picture
• The TV system setting
is inappropriate.
Noisy sound

Reset function

Press the RESET button on your remote control.
Your TV will go blank for a few seconds
then the "Initial Setup" menu will appear.
TV
Pressing RESET will set your TV to the factory
setting, but certain problems may be solved.
Possible cause
• Check the antenna cable and connection
• Check the antenna setup.
• Display the "Channel Setup" menu and
• Display the "Channel Setup" menu and
• Try using an external booster.
• Turn off or disconnect the external booster
• Display the "Channel Setup" menu and
• Display the "Channel Setup" menu and
Solutions
on the TV, VCR and at the wall.
Contact a Sony dealer for advice.
select "Manual Program" to preset the
channel again.
set the "Signal Booster" to "Auto" from
"Manual Program".
if it is in use.
set the "Signal Booster" to "Off" from
"Manual Program".
select the appropriate "TV System" from
"Manual Program".
Page
23
–
21
21
–
–
21
21
continue
Additional Information
25