Alpina RUN-SYSTEM-CLASSIC-LIGHT Mode D'emploi page 8

battery of the same type and voltage. To insert the new battery go
back in reverse order through the steps for removal. Notes: Battery
replacement must be carried out by an adult. Check the polarity of
the battery when inserting. Do not attempt to recharge batteries and
do not under any circumstances throw them onto a fire. Remove
the battery if the device is not going to be used for a lengthy period.
Improper use can lead to the risk of the battery exploding or leaking.
Leaky or otherwise damaged batteries may cause irritation if they
come into contact with the skin. Suitable protective gloves should
therefore be worn for handling them. Please note that batteries may
not be disposed of as household waste (fig. 11) but should instead
be taken to a dedicated collection point e.g. your local recycling
centre. Appliances bearing this symbol (fig. 11) are subject to
European Directive 2002/96/EC. All waste electrical and electronic
equipment must be disposed of separately from household waste
using the public facilities provided for the purpose. Proper disposal
of waste equipment enables you to avoid causing environmental
damage and any risk to your personal health. Further information
on the correct disposal of waste equipment can be obtained from
your local authority, recycling centre or the shop where you bought
the product. Remember the environment! Cleaning and storage:
To clean the light, use a damp cloth only. Cleaning agents or other
chemicals may damage the product. The battery must not be
exposed to excessive heat e.g. from sunshine or fires. Improper
removal of the battery may cause the risk of an explosion. Note: The
light source in this light cannot be replaced; when the light source
reaches the end of its service life the whole unit must be replaced.
FR : Remarques :
Le feu arrière à LED ne remplace par le dispositif technique
d'éclairage pour cyclistes prescrit par le §67 de la législation
allemande sur les licences routières (StVZO). Prière d'utiliser le feu
arrière à LED uniquement avec ce casque cycliste et de l'installer
sur le casque comme indiqué sur l'illustration (Fig. 1). Le feu