Installation; Electrical Connection - Brandt SM2606B Manuel D'instruction

Do not remove the light brown Mica cover that is attached on the right side to the
oven cavity to protect the magnetron.
e)

Installation

1. This appliance shall not be placed in a cabinet.
In order to obtain an optimal ventilation of your microwave oven, insert the plastic pin provided
with this instruction manual behind the appliance into the specified hole (Fig 2). Then, place the
appliance against the wall, the optimal ventilation being guaranteed by the plastic pin length.
Leave a minimum clearance of 12 inches (30cm) above the oven, 3 inches (7.5cm) at the left
side and leave the right side open (Fig 1).
Do not remove the legs from the appliance. Do not block airflow outlets, blocking the outlets can
damage your microwave oven.
Fig. 1
Fig 2
2.

Electrical connection

• Your installation must be protected by a 16 Amp thermal fuse.
• It is mandatory to use a power point with a ground terminal, connected in accordance
with current safety regulations.
• In your electrical installation, provide a device that is accessible to the installer, capable of
separating the appliance from the mains power and whose contact opening is at least 3 mm
at all of the poles.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
WARNING: Do not install oven over a range cooktop or other heat-producing appliance. If
installed near or over a heat source, the oven could be damaged and the warranty would be void.
The accessible surface may be hot during operation.
1. 7.5 cm
2. 30 cm
3. open
32