Resistance Measurements - Klein Tools CL360 Manuel D'utilisation

ENGLISH
CONTINUITY
1. Insert RED test lead into VΩ jack
COM jack
4
Continuity
display.
2. Remove power from circuit.
3. Test for continuity by connecting conductor or circuit with test
leads. If resistance is measured less than 10Ω, an audible signal
will sound and display will show a resistance value indicating
continuity. If circuit is open display will show "OL".
Black lead Red lead
DO NOT attempt to measure continuity on a live circuit.

RESISTANCE MEASUREMENTS

1. Insert RED test lead into VΩ jack
COM jack
4
Resistance
display.
2. Remove power from circuit.
3. Measure resistance by connecting test leads to circuit. The
meter will auto-range to display the measurement in the most
appropriate range.
Black lead Red lead
NOTE: When in a Resistance setting and the test leads are open
(not connected across a resistor), or when a failed resistor is under
test, the display will indicate O.L. This is normal.
DO NOT attempt to measure resistance on a live circuit.
10
OPERATING INSTRUCTIONS
, and rotate function selector switch
setting. The Continuity icon will appear on the
, and rotate function selector switch
Ω
setting. The Resistance icon will appear on the
, and BLACK test lead into
5
, and BLACK test lead into
5
to the
2
to the
2