For Your Child's Safety And Health; Warning; Before First Use; Cleaning Bottles - Philips Avent SCF334/31 Mode D'emploi

English
16

For your child's safety and health

Warning

Warnings to prevent harm to children:
-
Always use bottles and nipples with adult supervision. Do not allow your child to play with small
parts or walk/run while using bottles or cups.
-
Never use feeding nipples as a soother, to prevent choking hazard.
-
Continuous and prolonged sucking of fluids will cause tooth decay.
-
Always check the temperature of the food before you feed your baby to prevent burns.
-
Throw away any part at the first signs of damage or weakness.
-
Keep all components not in use out of the reach of children.
-
Do not alter the product or parts of it in any way. This may result in unsafe functioning of the
product.
Cautions to avoid damage to the product:
-
Do not place in a heated oven, plastic can melt.
-
Plastic material properties may be affected by disinfection and high temperatures. This can affect
the fit of the dome cap.
-
Do not leave a feeding nipple in direct sunlight or heat, or leave in disinfectant for longer than
recommended because this may damage the product.

Before first use

Before first use, disassemble all parts, clean and optionally disinfect the bottle. Inspect the bottle
and feeding nipple before each use and pull the feeding nipple in all directions to prevent a choking
hazard. Throw away at the first signs of damage or weakness.

Cleaning bottles

To ensure hygiene, clean the parts of the bottle mentioned in section ‚Cleaning' before each use. Also
clean all parts after each subsequent use. You can optionally disinfect by following the instructions in
section ‚Disinfection (optional)' .
Make sure that you wash your hands thoroughly and that the surfaces are clean before contact
with cleaned components. Excessive concentration of detergents may eventually cause plastic
components to crack. Should this occur, replace immediately. Inspect the bottle and feeding nipple
before each use and pull the feeding nipple in all directions to prevent a choking hazard. Throw away
any part at the first signs of damage or weakness.

Assembling bottles

When you assemble the bottle, make sure you place the dome cap vertically onto the bottle so that
the nipple sits upright (Fig. 26). To remove the dome cap, place your hand over the dome cap and
your thumb in the dimple of the dome cap (Fig. 27). The nipple is easier to assemble if you wriggle it
upwards instead of pulling it up in a straight line (Fig. 28). Make sure you pull the nipple through until
its surface is level with the surface of the screw ring (Fig. 29).