Cycle Guide - Whirlpool WDF550SAH Guide D'utilisation

To add rinse aid, open the dispenser
■
lid by gently pushing in the center of
the lid with your thumb while lifting up
on the edge.
Pour rinse aid into the opening until
■
the indicator level shows that it is full.
Do not fill the reservoir above the full
level indicator. Excess rinse aid can
cause suds and water to overflow
during the wash cycle.
Close dispenser by pushing down
■
gently on the lid until it clicks into
place.
5.
Select a cycle
NOTE: Heavier cycles and options lengthen cycle times. Choose
a cycle appropriate for the food soils and dishes that you load. See
the cycle descriptions in the Cycle Guide section.
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the cycle for
the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will automatically
compensate by adding time, heat, and water as needed.
The dishwasher remembers the cycle and options selections from the most recently completed cycle. To run the same cycle and options as the
last time, touch the START/Pause button twice—once to wake up the controls, and again to start the dishwasher.
Use for rinsing dishes, glasses, and silverware that will not be washed right away.
Do not use detergent.
This cycle senses the soil amount, to adjust amount of water and time needed.
Use for hard-to-clean, heavily soiled pots, pans, casseroles, and regular tableware.
Includes Heated Dry option.
This cycle is recommended for daily, regular, or typical use to completely wash and dry a full
load of normally soiled dishes. This dishwasher's government energy certifications were based
on the Normal cycle with only the Heated Dry option selected.*
For lightly soiled loads. Includes Heated Dry option.
For lightly soiled glassware. Includes Heated Dry option.
For fast results, the Quick cycle will clean lightly soiled loads that do not need drying.
Includes Heated Dry option.
NOTE: Some detergents are not recommended for short wash cycles; please refer to your
detergent packaging for more information.
*No other washing and drying temperature options were selected, and the diswasher was not subjected to truncated testing. Rinse aid was
not used, and there was no detergent used in the prewash.
6.
You can customize your cycles by selecting the
options desired (see the Cycle Guide). If you
change your mind, touch the option again to turn
off the option. If an invalid option is selected for
a given cycle, the lights will flash. Adding options
may increase the cycle time.
7.
NOTE: If needed, run hot water at the sink nearest your
dishwasher until the water is hot. Turn off water. With door
firmly closed touch the START/Pause button.
IMPORTANT: If the door is opened for any reason after the cycle is
started (even during the delay time), the Start/Pause button must be
touched again after the door is closed. If Start/Pause button is not
touched, the cycle will not resume.
8.
dishwasher
When the cycle is complete, the
Complete light will remain on until
the door is opened and closed or
the Start/Pause button is touched.

CYCLE GUIDE

CYCLES
4
Select options
Start or resume a cycle
Follow the progress of your
ESTIMATED WATER USAGE
WASH TIME GALLONS
W/O OPTIONS (LITERS)
HH:MM
0:10 2.1 G
(8.0 L)
1:45 - 3:18 2.9 - 5.8 G
(11.1 - 21.8 L)
2:30 - 2:50 5.8 G
(22.1 L)
1:30 - 2:10 2.9 - 5.6 G
(11.1 -21.2 L)
1:45 5.0 G
(19.0 L)
1:45 4.9 G
(18.4 L)
0:55 4.0 G
(15.0 L)