Bosch SHX89PW75N Notice D'utilisation page 47

Fault Cause
Dishes not dry. No or too little rinse aid in the dis-
penser.
Wash cycle selected without drying. Select wash cycle with drying.
Water collecting in depressions on
the dishes and silverware.
The combined detergent used has
a poor drying performance
extraDry to increase drying not acti-
vated.
Dishes were removed too early or
drying process had not ended yet.
The eco rinse aid used has a limited
drying performance.
Plastic dishes Inherent properties of plastic.
not dry.
Silverware not Silverware not arranged properly in
dry. the silverware basket.
Silverware not arranged properly in
the third rack.
Dishwasher No dishwasher fault.
interior wet
after rinse
cycle.
* This is an optional feature which may or may not be included with your dishwasher.
Troubleshooting en-us
Remedial action
Refill rinse aid.
~ "Dishwasher Cycles" on page 32
Arrange dishes in a sloping position,
arrange affected dishes as sloping as possi-
ble.
Use different combination detergent with
better drying performance. Use of rinse aid
also increases the drying performance.
Activate extraDry. ~ "Dishwasher Cycle
Options" on page 33
Wait until wash cycle ends or wait until 30
min after wash cycle ends before removing
dishes.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastics do not absorb heat and therefore do
not dry as well.
Separate silverware if possible, prevent con-
tact points.
Arrange silverware properly and separate if
possible.
With "condensation drying", steam con-
denses into water droplets onto the walls of
the dishwasher tank. The steam pressure
inside the dishwasher pumps the water out
of the dishwasher.
47