Snapper XD SXDCS82 Guide D'utilisation page 34

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE
TOP PLaTE FiLinG anGLE
CORRECT 30° – file holders are marked with guide marks to align file properly to produce
correct top plate angle.
LESS THAN 30° – for cross cutting.
MORE THAN 30° – feathered edge dulls quickly.
Top Place Filling Angle
Side Plate Filling Angle
Correct
Hook
SiDE PLaTE anGLE
Correct 80° – Produced automatically if you use the correct diameter file in the file
holder.
Hook – "Grabs" and dulls quickly; increases the potential of kickback. Results from using
a file with a diameter too small or a file held too low.
Backward Slope – Needs too much feed pressure; causes excessive wear to the bar and
chain. Results from using a file with a diameter too large or file held too high.
Backward Slope
Incorrect
Incorrect
Raker (Depth Gauge) Clearance
34
1/32"
(0.6 mm)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1696773

Table des Matières