Operation - Snapper XD SXDCS82 Guide D'utilisation

OPERATION

STaRTinG anD STOPPinG ThE Chain Saw
a. To start the chain saw:
• Make sure chain tension is at desired setting. Refer to adjusting the chain tension in the Care
and Maintenance section of this manual.
• Make sure the chain cover lock knob is tight to the chain cover.
• Make sure no objects or obstructions are in the immediate vicinity which could come in contact
with the bar and chain.
• fit the battery into the chain saw.
• Press the power button on the left of the rear handle. you will hear two beeps signalling the
chain saw is active.
• Press in the safety lock. This makes the trigger switch operational.
• Press and hold the trigger switch and keep it pressed for continued operation.
B. To stop the chain saw:
• Release the switch trigger to stop the chain saw.
• Upon release of the trigger switch, the safety lock will be automatically reset to the lock
position.
On/Off Button
Switch Trigger
nOTE: It is normal for the chain to coast to a stop once the trigger switch is released.
16
Safety Lock Buttom