Ash Pan Kit (Ep20Pad) - Timberwolf Economizer Serie Manuel D'installation Et D'opération

optional installation
EN
6.3

ash pan kit (EP20PAD)

WARNING
!
• Failure to achieve a good seal between the ash opening and ash plug will result in an over-fire condition that
could cause damage to the appliance.
Provisions have been made on the appliance to install an optional ash drawer kit.
note:
It is recommended to install the rails on the pedestal base prior to installing the
pedestal assembly to the firebox.
• If the appliance has been previously operated, it must be cold and the ashes must
be removed in order to access the ash plug.
• If the pedestal has been installed with the opening to the back, it will be necessary
to lay the appliance onto its back, remove the pedestal and re-install it with the
opening to the front. It is recommended all fire brick, including baffles, be removed
prior to placing the appliance on its back.
• From the underside of the appliance, remove the nuts that secure the ash opening
cover plate.
• Install the ash pan rails using the screws provided.
• Snap the magnets into place.
• Slide the ash drawer into the ash housing.
• Install the handle using the screws provided and affix the logo to the ash pan housing cover as illustrated.
• Place the ash pan housing cover in front of the opening, engaging it into the slots.
• Remove the small light weight brick that was covering the ash opening and discard. It is important that the area
around the ash opening be cleaned well to ensure that a proper seal is created between the new ash plug and the
ash opening.
• Once the area surrounding the opening has been cleaned, place the new ash plug (supplied) over the opening,
allowing the protrusion on the brick to recess into the opening on the bottom of the firebox.
26
W415-1463 / E / 08.20.18
The kit allows for convenient removal of excess ash.
LOGO
PLACEMENT
ASH OPENING
COVER PLATE