Covering Skin Areas - Philips Lumea Comfort Mode D'emploi

EngliSh
26
When you turn on Philips Lumea Comfort, its
intensity level is automatically reset to level 1. At
the start of each session, only one intensity light is
on: the intensity light for level 1. This means that, at
the start of each session, you have to increase the
intensity to the highest level that still felt comfortable
in the previous session.

Covering skin areas

You have to administer the pulses in rows. Start
at one end of each row and progress sequentially
towards the other end. This technique allows better
control over skin coverage and helps avoid treating
the same area more than once or overlapping areas
treated.
When you place Philips Lumea Comfort on the skin,
the device creates temporary pressure marks on the
area treated. These marks can be used to position
the device for administering the subsequent pulse.
- Try to avoid overlapping pulses! Do not
treat the same area of skin more than
once during a hair removal session!
- if your skin blisters or burns, STOP
USing ThE dEViCE iMMEdiaTElY!