Kemper MiniFil 65150 Mode D'emploi page 60

• Now place the new suspended matter filter in the MiniFil. While doing so,
ensure that the foamed seal labelled in Fig. 5, Pos. 3.2 faces the inside of the
device as can be seen in the figure.
• After this, screw the cover back to the MiniFil. When doing so, ensure that the
individual rows of small blow-out slots face the underside of the MiniFil.
After replacing the relevant filter medium please carry out the following steps:
• Plug the power cable back into the socket and turn on the device. The green
power lamp on the pushbutton (Fig. 3, Pos. 1) should come on and show the
device is running normally.
• Dispose of the used filters according to official regulations. Please request the
relevant waste codes from the local waste disposal service.
• Finally, the maintenance area is to be cleaned, for example with an industrial
vacuum cleaner for dust class "H".
Figure 5, Suspended matter filter replacement
- 60 -
Technical modifications and errors expected.
KEMPER MiniFil Operating manual - EN