Canvas FHWS80031 Instructions D'assemblage page 15

28 Product No. 085-1573-8 | Model No. FHWS80031
Burner will not light using igniter
Burner will not light with match
LP gas tank valve is closed
LP gas tank is low or empty
LP gas leak
Battery needs to be changed
Electrode and burners are wet
Electrode cracked or broken — sparks at crack
Wire loose or disconnected
Wire is shorting (sparking) between
igniter and electrode
Bad igniter
LP gas tank is low or empty
LP gas leak
Coupling nut and regulator not fully connected
Disengagement of burner to valve
Spider webs or insect nest in burner/venturi tube
Burner ports clogged or blocked
Make sure regulator is securely attached to the LP gas tank per
"Installing LP Gas Tank," then turn LP gas tank valve to "OPEN"
1. Turn LP gas tank valve to "CLOSED"
2. Wait 5 minutes for gas to clear
3. Follow "Checking for Leaks" section
Replace the "A A" battery (follow assembly step for inserting battery)
Wipe dry with cloth
Replacement part(s) may be needed — contact Customer Care at
1-888-670-6684
Replacement part(s) may be needed — contact Customer Care at
1-888-670-6684
Replacement part(s) may be needed — contact Customer Care at
1-888-670-6684
Replacement part(s) may be needed — contact Customer Care at
1-888-670-6684
Check if LP gas tank is empty
1. Turn LP gas tank valve to "CLOSED"
2. Wait 5 minutes for gas to clear
3. Follow "Checking for Leaks" section
Turn the coupling nut about one-half to three-quarters additional
turn until solid stop. Tighten by hand only — do NOT use tools
1. Clear burner/venturi tube
2. Check for bent or kinked hose
Re-engage burner and valve
Clean burner/venturi tube
Clean burner ports
29
w or