Using The Appliance On The Shoulders, Chest, Back And Legs; How To Achieve Optimal Results; Maintenance Phase - Philips TT3003 Mode D'emploi

English
30
using the appliance on the shoulders, chest,
back and legs
If you use the appliance to treat your shoulders,
chest, back and legs you may have to recharge the
appliance during the treatment. This is normal. How
long you can use the appliance depends on the size
of the treatment area and the intensity setting used.
Tip: If you want to treat your back and your shoulders,
you require the help of your partner or a friend to
guarantee complete coverage and best results.
Tip: The back and chest are often tanned. Take special
care to select the appropriate intensity for treating the
tanned skin to prevent skin reactions.

how to achieve optimal results

- It is normal that hairs are still visible after the first
few treatments (see chapter 'Introduction', section
'Working principle' for more information).
- To remove all hairs successfully and prevent
the hair follicle from becoming active again, the
treatments have to be repeated once every two
weeks for the first two to three months. Your skin
should be smooth by then. Please read section
'Maintenance phase' to find out how you can keep
these results.

Maintenance phase

- To ensure that your skin stays smooth, we advise
you to repeat the treatment every four to six
weeks. The time between treatments may vary
based on your individual hair regrowth and also
across different body areas. If too many hairs
grow back between treatments, simply shorten
the treatment interval again, but do not treat any
area more often than once every two weeks.