SilverCrest SMS 50 A1 Instructions D'utilisation Et Consignes De Sécurité page 30

• Do not place burning candles or other open
fire on or next to the product.
• Check the product before every use!
Discontinue use if any damage to the product
or the charging cable is detected!
• If you notice smoke or unusual noise or odour,
switch the product off immediately.
• Sudden temperature changes may cause
condensation inside the product. In this case,
allow the product to acclimatize for some time
before using it again to prevent short circuits!
• Do not operate the product near heat
sources, e.g. radiators or other devices
emitting heat!
• Do not throw the product into fire and do not
expose to high temperatures.
DANGER!
Do not try to open the product! It has no internal
parts requiring maintenance.
DANGER! Radio interface
• Switch the product off on aeroplanes, in
hospitals, service rooms, or near medical
electronic systems. The wireless signals
transmitted could impact the functionality of
sensitive electronics.
• Keep the product at least 20 cm from
pacemakers or implantable cardioverter
defibrillators, as the electromagnetic radiation
may impair the functionality of pacemakers.
• The radio waves transmitted could cause
interference in hearing aids.
• Do not place the product near flammable
gasses or potentially explosives areas (e.g.
paint shops) with the wireless components
on, as the radio waves emitted can cause
explosions and fire.
• The range of the radio waves varies by
environmental conditions. In the event of
wireless data transmission, unauthorised
third parties receiving the data cannot be
excluded.
30 GB/IE
• The OWIM GmbH & Co KG is not responsible
for interference with radios or televisions due
to unauthorised modification of the product.
The OWIM GmbH & Co KG further assumes
no liability for using or replacing cables and
products not distributed by OWIM. The user of
the product is fully responsible for correcting
interference caused by such unauthorised
modification of the product, as well as
replacement of such products.
WARNING! Ensure that:
• no direct heat sources (e.g. heating) can affect
the product
• the product is not exposed to bright artificial
light
• any contact with splashed and dripping water
and corrosive liquids is avoided and the
product is not operated in the vicinity of water.
In particular, the product should never be
submerged in liquid; do not place any vessels
filled with liquid, for example, vases or drinks,
on or near the product
• the product is not used in the immediate vicinity
of magnetic fields (e.g. speakers)
• no fire sources (e.g. burning candles) are
placed on or near the product
• no foreign objects penetrate the device
• the product is never subjected to extreme
temperature fluctuations as this could result
in condensation and electrical short circuits.
However, if the product was subjected to
extreme temperature fluctuations wait (approx.
2 hours) until the product has reached ambient
temperature before use
• the product is never subjected to excessive
shocks and vibrations
• connected cables are always laid in such a
manner that nobody can step on them or trip
over them. There is a risk of injury
• no objects are placed on a connected cable
and cables are not connected over sharp
edges because they could be damaged
otherwise.