Programming An Intercom Call From The Indoor Station To The Smartphone (Optional) - Urmet 1083/83-US Notice D'installation

(maintaining any parameters that had already
been confi gured);
• shorter than 2s or longer than 4s, the
device will be restarted.
• after 5 short consecutive presses (at time
intervals shorter than 1s) the device will
restore its factory parameters and signal
the event with a fl ashing red/orange/green
LED light, to then switch to the confi guration
mode.
3. LAN connector: Ethernet port for wired
connection to the home network.
4. Jumpers to defi ne the type of power supply
to the device.
Power from external local power
supply (DEFAULT)
DO NOT MOVE
5. +/- 24V terminals: external local power supply
terminals.
6. LINE IN, LINE OUT terminals: connection to
the system bus.
7. Jumper Z: line termination setting.
Line termination must be activated on a
device connected at the end of a line without
a new section restarting from the LINE OUT
terminals.
Termination on (DEFAULT)
Termination off
8. CODE dip switches: these are used to defi ne
the column number.
• 1-3: Dip switches not used.
• 4-8: these defi ne the column number.
For no. 4 to 8 dip-switch settings, refer
to the System 2Voice manual.
O N
=
6
O N
=
Power supply (provided)
1
1. N, L terminals: Input voltage 110/230Vac
2. V-, V+ terminals: Call-Forwarding device
power voltage output
3.4. PROGRAMMING AN
INTERCOM CALL FROM
THE INDOOR STATION TO
THE SMARTPHONE
(OPTIONAL)
IMPORTANT! To program the following optional
service for a specifi c user, the user must have
previously paired their CallMe app to the multi-user
call sender device.
Go to the apartment station to be programmed as
caller.
There are two different programming methods
(check which method is used in the instruction
manual supplied with the product):
A) Programming without picking up the
handset (Vmodo and Miro).
Per Mod. Vmodo:
1. Hold the button pressed for longer than
5 seconds. The
slowly to indicate that programming mode
is selected.
2. Select Auto-insertion from the smartphone
to the external unit. Go to step 3b.
For Miro:
1. Establish a call from the door unit to the
apartment station.
2. On your smartphone, answer the call and
leave the conversation open.
3. On the apartment station:
a. hold the button
than 5 seconds; the yellow LED will blink
slowly to indicate that programming
mode is selected;
b. Then press the button to be programmed
(e.g. /
2
V- V- V+ V+
NC NC N L
button will blink red
pressed for longer
for Mod. Vmodo,
DS1083-127
/ for