Programming - Urmet 1784/45 Notice D'installation Et Utilisateur

To check whether a certain key has been stored as MASTER, move it towards the front panel: the
matching bar (already in the top position) will fl ash and the buzzer will emit three beeps.
To return to normal functioning, move a MASTER key to the front panel for approximately 7 seconds.
After this time, the display will show for some seconds:
to indicate that all the MASTER keys have been stored; the fl ashing dot will then be displayed (only if
the display is enabled by means of dip-switch 2).

5.1. PROGRAMMING

To access programming, move a MASTER key close to the front panel.
The display will show several screen pages in sequence. Remove the key from the front panel when the
screen page you wish to access is shown on the display:
Current software version (display only)
User key storage/checking
User key deletion/replacement
Set door release time
If, by mistake, you remove the MASTER key at the wrong time and you enter a sub-menu different from that
set, simply present the MASTER key to the front panel briefl y to restore normal functioning.
In any case, if no operation is performed for 20 seconds after accessing programming, the device
automatically returns to normal functioning.
When returning to normal functioning from the programming phase, the following caption may appear on
the display for few seconds
(abbreviation of 'Store') this can be considered normal and indicates that the device is permanently storing
the information received. Wait for few seconds: the caption will disappear and the device will return to
normal functioning.
The individual sub-menus are illustrated below.
20
DS1784-005