Swissvoice DECT RTX 4002 Manuel D'utilisation page 25

DECT Repeater
4. Registration of the handset.
If the system PIN of your telephone was changed, it must be reset to "0000".
You must then register your handset again with the base station even if the handset
used was already registered with the base station, (consult your base station user
guide for more information). Now the LED flashes very quickly without interruptions.
5. Assign a repeater number.
You must now assign a repeater number to the repeater (selection: 2–7, for up to
6 repeaters). Please note that each number only can be assigned once, when using
more than one repeater. These numbers are independent of the mobile unit extension
numbers. Hook off by pressing the
between 2 and 7. When the repeater has accepted the chosen number, the LED
will flash a corresponding number of times. Accept the registration by pressing the
-key and then the
The LED goes off for 2 seconds, flashes for a brief moment and the remains conti-
nuously illuminated.
The registration of the repeater is completed. You can now disconnect the power and
move the repeater to the selected location (disconnecting the power will not delete the
registration.)
Note Before reinstalling the repeater (e.g. at another basestation), please reset the
repeater beforehand as described below:
1. Switch off the unit (disconnect the power plug).
2. Switch on for 1 to 5 seconds and switch off again.
3. Switch on for 25 to 35 seconds and switch it off again. Now the repater is
ready for a new registration.
-key (the LED stops flashing). Press a number
-key (hook on). The repeater is now automatically restarted.
23