Registration - Swissvoice DECT RTX 4002 Manuel D'utilisation

DECT Repeater
Before the repeater is installed, the repeater mode in the base station must be activated
( Menu Settings
base station.

Registration

The repeater registration procedure varies depending on the base station installed. The
base station, a mobile unit (handset) and the repeater must be accessible before regis-
tration can be performed. If you are connecting more than one repeater, registration
must be performed separately for each repeater.
Preparations
The base station and a mobile unit are ready for operation, the repeater is not yet con-
nected to the main supply.
1. Set the repeater in registration mode.
Insert the repeaters power plug for 1–5 seconds in the socket and then remove it.
Insert it once more and leave it there. The LED on the repeater flashes slowly after the
start. You now have five minutes to carry out the registration.
If the procedure is not carried out within this period you must start over again.
2. Set the base station in registration mode.
On most base stations, the procedure is started by holding down the "Registration" or
"Page" key for several seconds. Consult your base station user guide for more infor-
mation.
3. The LED on the front of the repeater flashes.
If the LED flashes very quickly without interruptions go to step 5. If the LED flashes
very quickly with brief interruptions go to step 4.
Range Repeater ) and the repeater must be registered to the
22