Dimensions - Chauvet DJ DMX-AN2 Guide De Référence Rapide

Product Overview
Signal
Indicator
Connection
Indicator
Ethernet
Port
*Press and hold the Reset Button for 3 seconds to reset the product to factory default settings. The
Power Indicator will flash.

Dimensions

1.5 in
39 mm
DC Power
This product has an external auto-ranging power supply that works with an input voltage range of 100 to 240 VAC, 50/60
Hz.
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
Power Over Ethernet
This product can receive power through the ethernet port, from a Power over Ethernet device.
Web Server
The DMX-AN2 Web Server can be accessed by any computer on the same network as the product. It allows network
access to configure settings such as the IP address and name of the product, and the individual settings for each DMX
port. The firmware of the product can also be updated through the Web Server.
To access the Web Server:
1. Connect the DMX-AN2 to a computer via the ethernet port on the back of the product.
2. On the computer, set the IP address of the network to have the same first three digits as the IP address of the
product. The default IP address of each DMX-AN2 is 2.0.0.1.
3. Enter the IP address of the product into the URL bar of a web browser application.
4. Press the Enter key.
5. Enter Admin in the User Name field, and Admin in the Password field. See
password.
If a new password is forgotten, the DMX-AN2 Web Server can be accessed by typing CHAUVETDJ as
both User Name and Password. This password cannot be changed.
Device Name
The device name for the DMX-AN2 can be changed through the Web Server, by clearing the Device Name field and
typing a new name. Click Apply to confirm changes.
IP Mode
The IP mode for the DMX-AN2 can be set through the Web Server, by clicking on the IP Mode drop-down menu and
selecting from DHCP IP or Manual IP. Click Apply to confirm changes.
IP Address
The IP address for the DMX-AN2 can be changed through the Web Server, by clearing the IP Address field and typing a
new IP address. Click Apply to confirm changes.
Art-Net™ function is limited to IP addresses beginning with 2 or 10. If the first digit of the IP address of
the DMX-AN2 is changed, the computer's network settings must be changed to match before the Web
Server can be accessed again.
DMX-AN2 QRG Rev. 1
QUICK REFERENCE GUIDE
Power
Indicator
9 VDC
Power In
Reset
Button*
2.5 in
64 mm
DMX A
Indicator
DMX B
Indicator
DMX A
Out
4.7 in
120 mm
DMX B
Out
New Password to change the
EN
2