How To Replace The Filters - Winix T1 Guide De L'utilisateur

FILTER CARE

2. How to replace the filters

Unit will automatically stop running when the Filter Cover or Top Cover are opened.
 Bottom Filters
 Anti-microbial PM 2.5 Filter & High Capacity AOC
 On the edge of each filter will show which way should face up.
Remove the Filter Cover
①
x Squeeze the the two tabs towards the
middle and pulling it toward yourself.
Remove the bottom filters from the
②
unit, they are protected inside plastic
wrap.
Remove filters from protective plastic wrap.
③
x Operating the unit without removing filters
from plastic may cause abnormal noise,
deformation, or fire as a result of overheating.
Install the bottom filters.
④
x Insert the filters into the
appropriate slots until the
back of the filter touches
the rear of the unit.
Replace the Filter Cover.
⑤
x Squeeze the the two tabs towards the
middle and attach it back to the unit.
English
3 High Capacity
AOC
Filter
2 Anti-microbial
PM 2.5 Filter
1 Fine Mesh Pre-Filter
Care and Maintenance
Carbon Filter
TM
Carbon
TM
23
T1