Remington Touch Control Lithium Hair Clipper HC5960 Mode D'emploi page 6

ENGLISH
• Select the desired boost level by pressing the boost button with the 3
position slide switch in the middle position. The display will indicate the level.
• Once the desired length and boost level have been selected slide the 3
position slide switch to the last position (the furthest down) to lock the
cutting length and turn the motor on.
• Note: Adjustments to length and boost can be done anytime the 3 position
slide switch is set to the middle position. Adjust the cutting length and or
boost level by pressing the arrows or boost button on the touch screen.
• Please note that the motor will only run when the 3 position slide switch is set
to lock, the last position (furthest down). This is to ensure the cutting length
does not adjust whilst you are cutting your hair.
• Press and hold the battery icon to display the remaining battery time in
minutes on the digital display. This can be used only when the 3 position slide
switch is set in the middle position.
, CAUTION
• NOTE: The comb must be attached to the appliance in order to use the hair
length selector.
, Before starting the cut
• Inspect the clipper making sure that it is free from hair and dirt.
• Seat the person so that their head is approximately at your eye level.
• Before cutting, always comb the hair so it is tangle free and dry.
, TO ATTACH A COMB
• Hold the comb with its teeth upward.
• Guide the comb rails into the slots on the side of the clipper head. Then push
the comb down until it seats on the adjustment arm.
, TO REMOVE THE COMB
• Holding the clipper with the blades facing away from you, firmly push the
comb upward and away from the blades.
, CAUTION
• If the incorrect comb is attached to the product for the desired cutting length,
a red warning light will illuminate to indicate this.
• Please inspect that the desired comb is attached or that the correct setting is
selected on the comb switch.
, INSTRUCTIONS FOR CUTTING HAIR
• For even cutting, allow the comb attachment/blade to cut its way through the
hair. Do not force it through quickly. If you are cutting for the first time, start
with the maximum comb attachment.
6