Pairing With The Cyclocomputer - Pioneer SGY-PM910H2 Mode D'emploi

Pairing with the Cyclocomputer

EN
This section describes how to pair the installed pedaling monitor sensors on
your bicycle to the SGX-CA500 Cyclocomputer.
● If you are using this product with a Cyclocomputer from another
manufacturer, the method of pairing is different. Refer to the User's Manual
of the Cyclocomputer you are using.
1. Check the sensor modes.
The actual sensor mode can be
confirmed from the way the LEDs of
the sensors light when the batteries
are installed, or from the way the LEDs
light on switching to each mode.
• Refer to Page 15 to switch the
modes.
2. Tap the [Sensors] icon in the
home screen of the SGX-
CA500.
The sensor list screen opens.
3. Rotate the bicycle's crank
set more than three rotations
to start the transmitters.
• After the transmitters are activated, it
may take more than 1 minute to pair
with the Cyclocomputer.
• Pair with the Cyclocomputer within
5 minutes after the transmitters are
activated.
24
4. Tap [Connect New] in the
sensor list screen of the
SGX-CA500.
The sensor connection menu opens.
5. Tap [Device Type] and then
[Pedaling Monitor R].
• For the left transmitter, tap [Pedaling
Monitor L].
• In single or dual power meter mode,
select the device type.
• If multiple sensors are activated,
bring the main unit closer to the
sensor, or specify the device number
to pair the sensor you want to pair.
Refer to the User's Guide (For WEB)
of the Cyclocomputer SGX-CA500
regarding how to specify a device
number to pair a sensor.