Pioneer SGY-PM910H2 Mode D'emploi page 21

By pushing the push switch in the right
transmitter for more than 3 seconds,
the LEDs on the right transmitter blink
green. When communication with the
left transmitter is enabled, the LEDs on
the left and right transmitters rapidly
blink orange.
Confirm that the LEDs on the left and
right transmitters blink when the mode
is switched. (If they do not blink, the
communication may have been done
with another pedaling monitor sensor
by mistake. Move somewhere away
from the other bicycles and do the
operation again.)
While the blinking takes place rapidly
for 10 seconds, push the switch
again during that time for more than
3 seconds. The mode is switched to
the dual power meter mode. When
the mode is switched, the LED starts
lighting orange for 10 seconds. If you
do not push long while the LEDs are
rapidly blinking orange , it is canceled
and so, you must do the operation
again.
• It may take several seconds to switch
the sensor mode depending on the
radio transmission conditions.
Switch to dual power meter mode
If the pairing with the left transmitter
fails, the LEDs of the right transmitter
blink red 5 times. Since the left
transmitter may be in the pedaling
monitor mode, switch to the
single power meter mode first on
Cyclocomputer SGX-CA500 and do
the above operation. If it still fails,
remove the batteries from the left and
right transmitters, wait for more than
one minute. Place the batteries back
and do the operation again.
After the mode is switched, install the
right transmitter cover and tighten the
screws to fix it in place. Use a tool that
can measure the torque to tighten the
screws.
• Tightening torque: 30 cN·m
• Install the transmitter cover and
the screws in firmly to ensure water
resistant performance.
• Do not lose the water-proof packing.
For how to pair with the cyclocomputer,
when using SGX-CA500, refer to Page
24 and if using a cyclocomputer
from another manufacturer, refer to the
User's Manual of that cyclocomputer.
EN
21