FALMEC Downdraft Evo Livret D'instructions page 27

- Fix the range hood supports at the bottom of the unit after checking for vertical and horizontal
alignment (see ill.2).
- Find installation type for outside exhaust version (a/b):
a) With motor unit (UM) (MU) fixed on the range hood: (see fig. 3 a) remove frontal blind plug
TC and the flange FM of the motor unit MU. Mount the flange FDL on MU.
Define the direction of air outlet by rotating the FL flange of the motor unit. Fix UM (MU) to
the range hood according to fig. 3b (top, bottom or side outlet). Connect the UM (MU) motor
outlet to the air discharge duct.
b) Remote motor positioned in a technical compartment protected against atmospheric
agents inside the residence: define the type of air outlet:
- Side or bottom with 90x220 mm rectangular piping (fig. 4a). Check that the blind plug TC (BP)
is mounted on the range hood, remove the rectangular plug corresponding to the desired
outlet and mount the supplied flange for rectangular pipe FR (fig.4b). Check that the FM flan-
ge is fixed on UM (MU) and place UM (MU) in the desired position. Connect the range hood
outlet to the UM (MU) inlet with suitable piping and connect the UM (MU) motor outlet to the
air discharge duct.
- Front or side with 150 mm diameter circular piping (fig. 4c). Remove the blind plug TC (BP),
mount the flange FC on the range hood, check that the flange FM is fixed on UM (MU) and
place UM (MU) in the desired position. Connect the range hood air outlet to the UM (MU)
inlet with suitable piping and connect the UM (MU) motor outlet to the air discharge duct.
Comply with current regulations for air discharge.
Recirculation version: in this version, the cooking fumes are reintroduced into the envi-
ronment after being purified by the carbone-zeo filters located in the filters structure kit
KACL.930. For their positioning see sec. F.
Place on the base of the unit a suitable evacuation grid to re-introduce the purified air inside
the kitchen.
- Carry out the electric connections between SC electronic box and connector locks of the
hood, following the diagram of fig. 5.
- Fasten SC in a suitable position on the wall unit base.
- Connect the motor power cable to the power supply, complying with the standards in force.
25