FALMEC Downdraft Evo Livret D'instructions page 24

3: 2° (2ND) SPEED
If the motor is at a different speed from the 2° (2nd), pressing the key will activate the 2° (2nd)
speed, and the T3 key will light up. If the motor is stopped, the key is disabled.
4: 3° (3RD) SPEED
If the motor is at a different speed from the 3° (3rd), pressing the key will activate the 3° (3rd)
speed, and the T4 key will light up.
If the motor is stopped, the key is disabled.
5: 4° (4TH) SPEED
If the motor is at a different speed from the 4° (4th), pressing the key will activate the 4° (4th)
speed, and the T5 key will light up.
If the motor is stopped, the key is disabled.
The 4° (4th) speed is timed; if the user does not change the speed, the motor will remain in 4°
(4th) for 14 minutes and then shift into 3° (3rd). The T5 key will switch off and the T4 key will
light up.
6: LIGHT - REMOTE BINDING
Light: Briefly pressing key T6 will turn the light on and off. The T6 key will light up if the light is on. If
the mobile part is closed, it will open, and the light will switch on after a few seconds.
Remote Binding (optional): With motor and light turned off, applying prolonged pressure on the T6 key
will activate remote binding mode. The T6 Key will flash for a maximum of 10 seconds. During
flashing, at least one radio control key must be pressed. The function will deactivate upon
completion of the 10 seconds, or earlier if a compatible remote control is detected.
KEY PRESSURE MANAGEMENT:
Prolonged pressure = finger pressed on key for at least 3 seconds, the function activates during pres-
sure.
Non-prolonged pressure = finger pressed on key for less than 3 seconds, the function activates upon
its release.
Radio control (optional): Place the device far from sources of electromagnetic waves which could
interfere with the range hood's electronic functions
Maximum operating distance 4 metres. This distance may vary in defect based on electro-
magnetic interference of other devices.
Function of the
remote control
Light Key
' - ' Key
' + ' Key
Timer Key
Code Change
(only in case of
malfunction)
22
Pressing the Light key will switch the light on/off
Pressing the '-' Key will decrease motor speed. If 1° (1st) speed is in gear, pressing
the '-' key will turn off the motor
If the motor is turned off, pressing the '+' key will activate the motor at 1° (1st)
speed. If the motor is operating, pressing the '+' key will increase motor speed up
to the maximum.
If the motor is active, pressing the timer key will activate/deactivate the timer
function
Press the "Luce" (Light) key together with the "Timer" key of the remote control
until the blue LED begins to slowly flash. If the "-" key of the remote control
is pressed within 5 seconds, the new code will be generated and memorised.
Memorisation is confirmed by 3 brief flashes of the LED.
To return to the default code, apply pressure on the "-" key together with the "+"
key for over 5 seconds. Memorisation of the default code will be signalled with 3
brief flashes of the LED.
Each time that a new code is generated or that the default code is set in the
remote control, it is necessary to also carry out the previously described Remote
Binding (Light Key of the pushbutton) procedure.
DESCRIPTION