Jung eNet FM AS 816 REG Instructions D'utilisation page 15

eNet
Actionneur TOR / volet roulant 8 / 4 voies, modulaire
Operating mode
Local Operation
Transmission of blind/shutter
position > 10%
Behaviour on voltage return
Configured venetian blind po­
sition
Configured slat position
Behaviour after the end of the
disabling function
Priority, lock­out protection
Priority, restraint
82581913
J:0082581913
Roller shutter
Venetian blind
Awning
Basic setting: Roller shutter
On, Off
Basic setting: On
On, Off
Basic setting: Off
No change
Configured value
Basic setting: No change
0 ... 100 %
Basic setting: 0 %
0 ... 100 %
Basic setting: 0 %
no change
Last value
Down
up
Basic setting: No change
0...4
Basic setting: 1
0...4
Basic setting: 2
15/18
Roller shutter
A rolling shutter or an awning
is controlled for which the Fa­
bric stretching function is re­
quired.
Venetian blind
A Venetian blind is controlled.
Awning
An awning is controlled for
which the Fabric stretching
function is required.
Blocks the output for operation
using the Prog button.
The current position of the
blind/shutter is always trans­
mitted when the blind/shutter
comes to a stop. This parame­
ter makes it possible to specify
that, during travel, the position
is saved when the blind/shut­
ter position changes by more
than 10%. The saved value
can then be polled from the
eNet server.
Defines the behaviour of the
output after voltage return.
RMD design: Bus voltage re­
turn
If the value "Configured posi­
tion" is entered for the para­
meter "Behaviour after voltage
return", then the blind/shutter
position set here is approa­
ched.
If the value "Configured posi­
tion" is entered for the para­
meter "Behaviour after voltage
return", then the slat position
set here is approached.
Behaviour of the output when
a block is removed.
Specifies the priority for recal­
ling and removing a scene of
type Lock­out protection for
the channel.
Specifies the priority for recal­
ling and removing a scene of
type Forced position for the
channel.
13.03.2014