Jung eNet FM AS 816 REG Instructions D'utilisation page 11

eNet
Actionneur TOR / volet roulant 8 / 4 voies, modulaire
Channel 4, 8
Settings, "Switching" channel
Parameters
Manual commissioning
Operating mode
Local Operation
82581913
J:0082581913
Switching, shutter/blind
Basic setting: Venetian blind
Setting options, Basic set­
ting
On, Off
Basic setting: On
Switching
Buttons
Flashing
Continuous on
Continuous off
Basic setting: Switching
On, Off
Basic setting: On
11/18
Specifies whether Channels 4
and 8 work as switching or Ve­
netian blind outputs.
Explanations
Blocks manual commissioning
for the device channel. In the
"Off" setting, the device can­
not be reset to the factory set­
ting.
Switching
After switch­on, the device re­
mains stable in the "On" state,
and stable in the "Off" state af­
ter switch­off.
Buttons
The device switches "On"
when any channel button of a
radio transmitter is pressed
and "Off" when the button is
released. It is irrelevant whe­
ther the "On" or "Off" channel
button is pressed.
Flashing
Switch­on starts flashing and
switch­off stops flashing. The
default flash frequency is 1
Hz. This frequency is also the
maximum flash frequency.
The flash frequency can be
changed using parameters.
The parameter "Switch­off de­
lay" is used for the pulse time
and the parameter "Switch­on
delay" for the pause time.
Continuous on
The output switches to conti­
nuously "On". All operations of
radio transmitters and the
Prog button are ignored.
Continuous off
The output switches to conti­
nuously "Off". All operations of
radio transmitters and the
Prog button are ignored.
Blocks the output for operation
using the Prog button.
13.03.2014