Jung eNet FM AS 816 REG Instructions D'utilisation page 13

Actionneur tor / volet roulant 8 / 4 voies, modulaire
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

eNet
Actionneur TOR / volet roulant 8 / 4 voies, modulaire
Behaviour on voltage return
Timer behaviour, voltage re­
turn
Switch­off warning
Priority, lock­out protection
Priority, restraint
Priority, wind alarm
Priority, sun protection
Priority, twilight
Switch­off on brightness over­
shoot
82581913
J:0082581913
On
Off
Last value
Configured brightness
Basic setting: Off
Off
Restart
Basic setting: Off
On, Off
Basic setting: Off
0...4
Basic setting: 1
0...4
Basic setting: 2
0...4
Basic setting: 3
0...4
Basic setting: 0
0...4
Basic setting: 0
On, Off
Basic setting: On
13/18
Defines the behaviour of the
output after voltage return.
RMD design: Bus voltage re­
turn
Specifies whether the timers
for switch­on delay, switch­off
delay and run­on time remain
off after voltage return or whe­
ther they restart. Directly
connected to the parameters
"Switch­on delay", "Switch­off
delay" and "Run­on time".
If the switch­off warning is ac­
tive, the light is not switched
off directly. The light goes off
30, 15 and 6 seconds before
permanent switch­off. During
the switch­off warning, a
switch­on telegram effects di­
rect switch­on. It is not pos­
sible to terminate the time
using a switch­off telegram.
Specifies the priority for recal­
ling and removing a scene of
type Lock­out protection for
the channel.
Specifies the priority for recal­
ling and removing a scene of
type Forced position for the
channel.
Specifies the priority for recal­
ling and removing a scene of
type Wind alarm for the chan­
nel.
Specifies the priority for recal­
ling and removing a scene of
type Sun protection for the
channel.
Specifies the priority for recal­
ling and removing a scene of
type Twilight for the channel.
Allows automatic switch­off
according to the brightness. If
the parameter is On, then the
light controller switches off au­
tomatically when the bright­
ness setpoint is greatly excee­
ded. This parameter is not yet
active, as a light controller has
not yet been implemented.
13.03.2014

Publicité

Table des Matières
loading

Table des Matières