Projector Position; Projection Surface - Epson BrightLink Solo Guide D'installation Rapide

Note
Interactivity cannot be guaranteed if the screen is smaller than 58 inches (147 cm) measured diagonally
(minimum screen size for 16:9 widescreen aspect ratio).

Projector Position

The interactive module is designed to work with a ceiling-mounted projector. However, you can also use it
with a portable projector on a table or cart.
With any type of projector, you will need to recalibrate if you change the size, position, or resolution of the
image. This may happen more frequently when you use a portable projector.
If you use the interactive module with a portable projector, be aware of the following:
• You need to know the size, position, and location of the projected image before you can decide where
to mount the interactive module. Epson recommends that you determine the best position for your
portable projector, and mark the location on the table or floor so that you can always set it up in the
same place.
• Reflection of the light from the projector may cause the interactive module to malfunction.
• Epson recommends that you position the interactive module for the largest possible image size from
your portable projector(s).
• The person interacting with the image must avoid looking into the projector lens.
Warning
Never look into the projector lens when the lamp is turned on; the bright light can damage your eyes.

Projection Surface

• Your images must be projected on a hard surface, rather than a screen.
• If you are projecting on a wall-mounted board, make sure the distance
between the wall and the board is less than 6 inches (150 mm)
• Whether you are projecting on a wall-mounted board or a plain wall,
make sure the wall is flat and free from any obstructions, bulges, or
protrusions.
6
Whiteboard
Less than 6 inches
(150 mm)